MIL-DTL-3060G (AR)
assembly cover skirt shall catch beneath the edge of the body fold and restrain the cover from opening fully
when the partially opened box is inverted.
3.4.2 Hasp and latch. Mating parts of the body hasp and the latch shall meet without requiring
deformation of any box part, and the latch shall close and open freely. When closed, the latch of the
assembled box shall remain closed until manually opened.
3.4.3 Elevated temperature storage. Following storage of the box in its closed position at an air
temperature of not less than 163 degrees Fahrenheit for a period of not less than 24 hours and subsequent
return to ambient temperature, the cover of the box shall function as required in 3.4.1 and 3.4.2.
3.5 Airtightness of box assembly. The assembled box shall not release more than four (4) bubbles of
air for 15 seconds, or air leakage shall not exceed .4 cubic centimeter per 5 seconds when subjected to an air
pressure differential of three (3) pounds per square inch (psi).
3.6 Weld security.
3.6.1 Cover handle assembly. The cover handle of the box shall withstand a pull of 300 pounds for a
period of one minute without separation from the cover or failure of either link, clip, or any weld.
3.6.2 Latch, cover and hinge assembly. The latch, cover and hinge assembly shall withstand a pull of
300 pounds (lbs) for the M19A1 box.
3.6.3 Cover hinge assembly. The cover hinge assembly shall withstand a pull of 500 lbs for the
M2A1 box.
3.6.4 Hasp assembly. The assembly of the hasp to the box shall withstand a pull of 1000 pounds for
one minute without failure of the hasp or weld.
3.7 Gasket compression. The boxes shall have a gasket compression 0.090 ± 0.020 inches when
closed.
3.7.1 M19A1. The boxes shall have a gasket compression 0.0900+0.020 inches when closed.
3.7.2 M2A1. The boxes shall have a gasket compression 0.0900+0.020 inches when closed.
3.8 Workmanship.
3.8.1 Metal defects. The boxes shall be free of burrs, rough spots, sharp projections, cracks, splits,
buckles or sintered surfaces.
3.8.2 Foreign matter. The boxes shall be free of corrosion, chips, dirt, grease and other foreign
matter.
3.9 Ammunition lot Number. Ammunition lot number shall be assigned in accordance with
MIL-STD-1168.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business