MIL-DTL-3060G (AR)
a. Title, number and date of this specification
b. Quantity required and delivery schedules.
c. Serialization requirements, if applicable.
d. Quality conformance inspection, if other than specified in Section 4 of this specification.
e. First article sample requirements, if other than specified in Section 4 of the specification.
f. Packaging requirements, if other than specified in section 5 of this specification.
Referenced drawings 7553352 for M2A1 container or 7692103 for M19A1 container.
6.3 Measurement for gasket compression. Three pint contact of the container resting on blocks
may be used to overcome any rocking which might be encountered with the container resting on the
surface plate. However, since the measurement technique relies upon relative distances, care should be
taken to assure that there is no displacement on the referenced surfaces between the readings.
6.4 Inspection Equipment. The inspection equipment required to perform the examination and
tests prescribed herein is described in the Inspection Method Column in the tables starting with table II,
Inspection equipment used for acceptance of product should be capable of repeatable measurements, by
various experienced inspection/test personnel, to an accuracy of 10% or better of the total tolerance of the
characteristic being inspected. Any automated acceptance inspection equipment (AAIE) prove-out should
be performed in accordance with MIL-A-70625.
6.5 Definitions.
6.5.1 Inspection Lot. The term "inspection lot" is defined as a homogeneous collection of units
of product from which a representative sample is drawn or which is inspected 100 percent to determine
conformance with applicable requirements.
6.6 Alternate test method for airtightness of box assembly. The alternate test method for
airtightness of box assembly container should be conducted as described in 4.4.4.2 or 4.4.4.3 with
government approval.
6.7 Subject term (key word) listing.
M19A1, Small Arms Box
M2A1, Small Arms Box
6.8 Changes from previous issue. Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
14
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business