MIL-DTL-2427H (AR)
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2)
b. Conformance inspection (see 4.3)
4.2 First article inspection.
4.2.1 Submission. A first article sample shall be submitted for evaluation in
accordance with the provisions of 4.2.2. The first article sample shall consist of three
consecutively produced boxes of one grade, type and style which have been produced
using the same production processes, procedures and equipment as will be used in
fulfilling the contract. When polyethylene or polypropylene rope is used, a continuous
length of rope sufficient to perform the tests specified herein shall also be furnished. All
materials shall be obtained from the same sources of supply as will be used in regular
production.
4.2.2 Inspections to be performed. Samples may be subjected by the Government
to any or all of the examinations and tests specified in this specification and to any or all
requirements of the applicable drawings.
4.2.3 Rejection. If any box assembly or polyethylene or polypropylene rope
sample, if pertinent, fails to comply with any of the applicable requirements, the first
article sample shall be rejected.
4.3 Conformance inspection
4.3.1 Lot formation. Lot formation shall be in accordance with lot formation
requirement of MIL-STD-1916 paragraph "Formation and identification of lots or
batches".
4.3.2 Examination. Sampling plans and procedures for Major and Minor defects
shall be in accordance with MIL-STD-1916 except that continuous sampling plans may
be used if approved by the procuring activity.
- 19 -
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business